CGRC CAN Light On Even When the Bike Is Turned Off

CGRC CAN Light On Even When the Bike Is Turned Off

If you notice that the CGRC CAN status light remains on even after you’ve turned off your motorcycle, here’s what you need to know:

The CGRC CAN is designed to activate via vibration. This means that if there’s any movement or vibration near your bike, the CGRC CAN status light may turn on temporarily. After about a minute without detecting any vibrations, the status light will automatically turn off.

However, if your bike is stationary and the CGRC CAN status light remains consistently on, this could indicate an issue. In such cases, please take a photo of the back of the 8-pin module and contact Chigee Support for further assistance.

    • Related Articles

    • Introduction to CGRC CAN

      The Chigee CGRC CAN remote controller works by tapping into your bike's CAN-bus, analyzing the signals from the switches, and translating them into commands to control the AIO-5 Lite. Please note that the Chigee CGRC CAN is specifically designed to ...

    • Differences and Similarities Between CGRC CAN and CGRC LIN

      Similarities: Both CGRC CAN and CGRC LIN are specially designed remote controllers for BMW bikes. Differences: CGRC CAN: Controls the wonder wheel. (can be daisy-chained with other devices) CGRC LIN: Controls the wonder wheel + directly reads BMW's ...

    • Install CGRC Remote Control CAN

      During setup, all you need to do is plug the CGRC CAN into one of two module interfaces: either the 4-pin port for the RDC module, which handles tire pressure monitoring, or the 8-pin port for the DWA module, which is the bike's anti-theft alarm ...

    • Does AIO-5 drain the bike battery?

      The AIO-5 Lite / Play are equipped with low voltage battery protection. Once it detects low voltage（drops below 12 volts）, the device will shut down completely, ensuring it does not consume any more power from the battery. Therefore, it will not ...

    • CGRC CAN Module Not Lighting Up

      If your CGRC CAN module is not lighting up after installation, please try the following steps: 1. Verify Correct Installation: Ensure that CGRC CAN module is installed in the correct position. If you are unsure, please contact CHIGEE SUPPORT for ...