Using ETC or USB Power in Parallel: Requirements

• Related Articles

• Power AIO-6 via USB-C (Pre-Install/Test)

  AIO-6 Display can be temporarily powered via the USB-C diagnostic port located on the right side of the device, next to the SD card slot. This can be useful for initial setup or testing before full installation. Important Note: Using USB-C power ...

• SD Card Requirements & Usage

  Most CHIGEE Display models do not include an SD card by default. Please check your device type carefully before installation: AIO-6 Series → No SD card included. AIO-5 Lite → No SD card included. XR-2 → No SD card included. AIO-5 Play Series → ...

• Power and Test via USB-A to USB-C (Pre-Install)

  Before installing the Chigee Display onto your motorcycle, you can power the device through its USB-C port using a USB-A to USB-C cable. This allows you to complete the initial setup, perform firmware updates, or check functionality without ...

• Continuous Power Consumption: Specs & Standby Current

  All CHIGEE display features low-voltage battery protection. When the battery voltage drops below 12 volts, the device will automatically shut down to prevent any further drainage. Power specifications of AIO-5 lite Standby Current: 100uA (0.0012W) ...

• AIO-5 Lite Black Screen Recovery(Backlight On, But Won’t Boot)

  If your AIO-5 Lite shows a backlight when powered on but fails to fully start up, the issue is most likely due to a failed firmware update. In such cases, the system enters a recovery state and cannot complete the boot process. To resolve this issue, ...