The CG2 Fork Stem Mount (MFP0040) places your phone holder at the center of the motorcycle cockpit. It is an alternative when clip-on handlebars leave little room for a handlebar clamp.
Check the mounting point and parts
For a CG2 phone holder, choose the CG2-specific MFP0040 kit. Check the mounting hole and the space above it against the parts supplied with your kit.
CG2 phone holder
MFP0040 fork stem mount with its supplied fitting hardware
The tools specified for the supplied fasteners
A clear mounting position that does not obstruct steering, instruments or controls
If you are unsure whether the kit fits your motorcycle, contact us with the model, year, mounting-hole dimensions and a photo of the cockpit before installation.
Fit the CG2 fork stem mount
Check the fork stem opening and select the fitting components specified for that opening in your mounting kit.
Assemble and position the fork stem fitting as shown in the installation video below. Use the components supplied for the CG2 kit.
Tighten the fitting's securing fastener with the appropriate tool, following the kit instructions. Check that the base cannot turn or lift out.
Attach the CG2 holder to the mount and secure the holder connection with the supplied locking hardware.
Fit your phone, set the viewing angle, and check that the holder is secure. Turn the handlebars through their full range to confirm clearance before riding.
Do not ride with a loose base or a holder that interferes with the controls. If the fitting does not secure correctly, stop and check the kit and mounting-hole compatibility.
Fork stem installation video
The video demonstrates the fork stem installation method, which also applies to the CG2 MFP0040 mount. Use the CG2-specific kit and its supplied holder connection.
Install and connect your CG2 phone holder covers the power cable, phone clamp and charging checks after the mount is fitted.