During setup, all you need to do is plug the CGRC CAN into one of two module interfaces: either the 4-pin port for the RDC module, which handles tire pressure monitoring, or the 8-pin port for the DWA module, which is the bike's anti-theft alarm system.
Follow these steps to install
1. Locate the DWA / RDC module
2. Unplug the original connector. Connect CGRC CAN to the corresponding module. Refer to the video below for guidance.
1. No Hot-Swapping:
Do not connect or disconnect the CGRC CAN while your motorcycle is powered on.
Hot-swapping can generate error codes, potentially causing motorcycle malfunction.
2. Proper Installation Procedure:
Power off your motorcycle completely before installing the CGRC CAN.
After installation, ensure you reconnect the other end of the CGRC CAN.
Pair the CGRC Can with the AIO-5 lite
Once connected, you'll then need to pair the CGRC Can with the AIO-5 lite via Bluetooth. Refer to the video below for guidance.
Timeline:
0:00 - 0:25: Pair the CGRC Can with the AIO-5 lite
0:26 - 1:23: Control CGRC CAN