Use the included CG2 handlebar mount to secure the phone holder to a suitable round handlebar. Choose the adapter ring that matches the mounting position before tightening the clamp.
Before you start
The CG2 handlebar mount is designed for 22–32 mm handlebars. The CG2 manual lists adapter rings for 22 mm, 25 mm and 28.6 mm bars.
CG2 phone holder and handlebar clamp
The adapter ring matching your handlebar diameter
Clamp bolt and side locking set screw
Supplied installation tools, including the hex keys and 8 mm wrench for the holder connection
Check the space around the chosen mounting position. The phone and holder must not obstruct the motorcycle controls or restrict steering.
Fit the CG2 handlebar mount
Choose the clamp orientation that suits your motorcycle. The mounting connection can face upward or sideways, as shown in the CG2 manual.
Place the matching adapter ring around the handlebar, then fit the clamp over it. Align the ring's locating tab with the groove in the clamp.
Set the clamp angle and tighten the clamp bolt using the supplied hex key.
Connect the CG2 holder's threaded ball stud to the base. Tighten the connection with the 8 mm wrench, then fit and tighten the side set screw to help prevent loosening.
Fit your phone and check that the clamp and holder remain secure. Turn the handlebars through their full range and check clearance before riding.
If the clamp slips or the hardware does not fit, stop and recheck the adapter and assembly. contact us with your motorcycle model, handlebar diameter and photos of the mounting point if you need help.
Installation video
This CG2 installation video provides a visual reference for fitting the included handlebar mount. Use it alongside the written steps above.
For phone insertion, removal and power connections, see Install and connect your CG2 phone holder.