Power AIO-6 via USB-C (Pre-Install/Test)

AIO-6 Display can be temporarily powered via the USB-C diagnostic port located on the right side of the device, next to the SD card slot. This can be useful for initial setup or testing before full installation.

Important Note: Using USB-C power requires opening the waterproof cover, which leaves the port vulnerable to water exposure. We strongly advise against using USB-C power during actual riding, as water ingress could damage the device.

Power Limitations and Safety

If the device does not power on via USB-C, Please try the following steps:

• Use a different USB-A to USB-C cable (preferably a high-quality, data-capable cable)
• Ensure your power adapter supports at least 5V/2A output
• Try a different USB power adapter or power bank
  
• Avoid using high-output chargers, which may trigger the device’s protection mechanism and block power input
  

If the device still fails to power on, the issue is almost always related to the power source, not a defect in the device.

If the AIO-6 powers on via USB-C but later shuts down unexpectedly, displays a black screen, or restarts frequently, this typically indicates insufficient or unstable power — again, not an early hardware failure.

For reliable and safe operation — including during the initial setup — we strongly recommend powering the device using one of the following methods instead of USB:

• Connect the device directly to your motorcycle’s battery using the included wiring harness, as outlined in the user manual. Get to Know AIO-6
• Or, install the quick-release module, which provides secure power integration via your motorcycle.

About the Rear Main Wiring Port

Please note: the Main Wiring Harness Port on the back of the device cannot be powered via USB. It is designed only for connection to the CHIGEE harness for permanent motorcycle installations.

---

Recommended Alternative: AIO-5 Play

If USB power is your preferred method and you don't require camera support, consider our AIO-5 Play model. It is more suitable for light setups and temporary USB use scenarios.

• Related Articles

• Power and Test via USB-A to USB-C (Pre-Install)

  Before installing the Chigee Display onto your motorcycle, you can power the device through its USB-C port using a USB-A to USB-C cable. This allows you to complete the initial setup, perform firmware updates, or check functionality without ...

• Install CHIGEE Display (Step-by-Step Video)

  We have created an instructional video detailing the installation process. Please enable English subtitles for step-by-step instructions. Additionally, you have the option to use automatic translation for convenience. Installing Handlebar Mount ...

• Install CGRC Remote Control CAN

  During setup, all you need to do is plug the CGRC CAN into one of two module interfaces: either the 4-pin port for the RDC module, which handles tire pressure monitoring, or the 8-pin port for the DWA module, which is the bike's anti-theft alarm ...

• Power Cable Compatibility (AIO-5 Lite / AIO-6 / XR-2)

  Power Cable serves as a standard item and is universally compatible with all the CHIGEE models listed above for battery power connection. AIO-5 Lite AIO-6 XR-2 Switching Between Models If you're switching between supported models — for example, from ...

• Install Included Handlebar Mount

  Suitable for 22-32mm pipe diameter