Install External Tire Pressure Sensor

Please refer to the attached video for guidance on the installation process.

 If you need to replace the battery, kindly follow the instructions provided in the following video.

• Related Articles

• Install CHIGEE Display (Step-by-Step Video)

  We have created an instructional video detailing the installation process. Please enable English subtitles for step-by-step instructions. Additionally, you have the option to use automatic translation for convenience. Installing Handlebar Mount ...

• Install CGRC Remote Control CAN

  During setup, all you need to do is plug the CGRC CAN into one of two module interfaces: either the 4-pin port for the RDC module, which handles tire pressure monitoring, or the 8-pin port for the DWA module, which is the bike's anti-theft alarm ...

• One Tire Pressure Sensor Isn’t Working (No Pressure / No Data)

  If one wheel on the tire pressure monitor shows no data, start with the battery (for external sensors), then isolate whether it’s a pairing issue, a wheel/position issue, or a faulty sensor. Applies to: Chigee Display TPMS, G3 TPMS Step-by-Step (Do ...

• Sensor Batteries & Service Life (Internal vs External)

  MFP0018 Internal Sensors: Not replaceable; after battery depletion, a new internal sensor needs to be purchased. The battery life is approximately 2-3 year, but may vary based on tire pressure check frequency. MFP0019 External Sensors: Yes, when the ...

• BMW Tire Pressure Data Integration with Chigee Display

  Supported Scenarios Chigee Displays can directly access your BMW’s built-in Tire Pressure Monitoring System (TPMS) through the BMW 3-pin navigation connector in the following setups: AIO-5 Play for BMW plugged directly into BMW Nav Prep AIO-6 with ...