Install GPS module

Install GPS module

Install the GPS with the side marked with the GPS emblem facing upward at a horizontal angle. It can also be mounted on the backside of the cowl (bike shell), but only if there is no metal cover nearby.

Note: To prevent a decrease in reception sensitivity due to interference, install the GPS module at least 20cm away from the AIO-5 Lite unit and camera.

    • Related Articles

    • Install AIO-5 Lite / AIO-5 Play

      We have created an instructional video detailing the installation process. Please enable English subtitles for step-by-step instructions. Additionally, you have the option to use automatic translation for convenience. To enhance your experience with ...

    • Install CGRC Remote Control CAN

      During setup, all you need to do is plug the CGRC CAN into one of two module interfaces: either the 4-pin port for the RDC module, which handles tire pressure monitoring, or the 8-pin port for the DWA module, which is the bike's anti-theft alarm ...

    • AIO-5 Lite Does Not Powering On

      We recommend trying to power the AIO-5 unit via the USB Type-C port (located at the bottom of the device, next to the SD card slot) to see if it can start normally. 1. Please ensure that you use a power supply with a voltage greater than 5V and a ...

    • Install Handlebar Mount(AIO-5 Included)

      Suitable for 22-32mm pipe diameter

    • Can AIO-5 Lite be installed on my bike?

      The AIO-5 Lite can be installed on the majority of motorcycles. However, please ensure the following common considerations before making a purchase: 1、Cable Length Check if the cables for the front and rear cameras are long enough. The total cable ...