Power & Wiring
Power Cable Compatibility (AIO-5 Lite / AIO-6 / XR-2)
Power Cable serves as a standard item and is universally compatible with all the CHIGEE models listed above for battery power connection. AIO-5 Lite AIO-6 XR-2 Switching Between Models If you're switching between supported models — for example, from ...
Do Not Use BMW 3-Pin Nav Interface for ACC
We do not recommend connecting the ACC Wire to the BMW 3-Pin Navigation Interface, as it may cause problems with the entire motorcycle circuit if the ACC encounters any problems. For a safer and more reliable installation, we recommend connecting the ...
Connect Yellow ACC Cable Without a Fuse Box
If your motorcycle lacks a fuse box, you can connect the yellow cable to the tail light wiring harness instead. The tail light wiring is typically located inside the rear fender, under the seat, or near the tail light assembly. To access the tail ...
Introduction to Wiring & Power (CHIGEE Display)
Goal: reliable power and ignition-aware behavior (auto-on, Parking Monitor, 4G Live on LTE models). Wires: Red = Battery +, Black = Battery − (Ground), Yellow = ACC/Ignition sense. What each wire does Red (B+): permanent +12 V from the battery (use a ...
Locate the ACC Wire with a Multimeter
Start by finding the fuse box, then use a multimeter to identify the ACC wire. Set your multimeter to the DC voltage setting. Connect the black meter lead to the battery negative terminal. Use the red meter lead to probe the various wires. The ACC ...
Powering CHIGEE Display via Third-Party Power Managers (e.g., HEX ezCAN)
Short answer: For full functionality (e.g., remote camera access on camera models, LTE features on LTE models, and Parking Monitor), we recommend the factory method: wire the CHIGEE Display power harness directly to the motorcycle battery (+ / −) and ...
Using ETC or USB Power in Parallel: Requirements
There is no problem as long as the operating current of this device is 12V to 18V and the operating voltage is 0.6A.
Battery Protection: Auto Shut-Down Below 12V
When the system detects that your battery voltage drops below 12 volts, the device will automatically shut down to prevent further power consumption. This ensures the CHIGEE Display will not drain your motorcycle’s battery.
Power and Test via USB-A to USB-C (Pre-Install)
Before installing the Chigee Display onto your motorcycle, you can power the device through its USB-C port using a USB-A to USB-C cable. This allows you to complete the initial setup, perform firmware updates, or check functionality without ...
Continuous Power Consumption: Specs & Standby Current
All CHIGEE display features low-voltage battery protection. When the battery voltage drops below 12 volts, the device will automatically shut down to prevent any further drainage. Power specifications of AIO-5 lite Standby Current: 100uA (0.0012W) ...