To enable Wonderwheel control through the CHIGEE Display, your BMW must have “Preparation for navigation system (SA 272)” activated. The “Native Wonderwheel Control” listed in the compatibility table assumes SA 272 is active.

However, we’ve found that some BMW motorcycles are delivered without SA 272 activated from the factory. Please refer to this page to learn how to activate it.

Tip:

1. If you're not getting Wonderwheel control after installation, first make sure you've selected “CGRC” (not “NAV”) in Settings > Features > RC on your CHIGEE Display.
2. Then check whether your bike needs SA 272 activation.
3. If Wonderwheel control remains unavailable, we recommend using the CGRC Remote Pro — specially developed by CHIGEE.
   

Native data access is made possible by transferring ECU data to the CHIGEE device.

However, for certain models — especially pre-2017 — the required BMW data may not be present on the LIN bus. In such cases, the CHIGEE Display cannot access this data.

If your BMW is listed as supporting “Native data access” but you're still unable to read data:

1. If the CHIGEE Display is receiving power from the BMW Nav Prep and can access Wonderwheel control, the device is functioning normally.
   In this case, the issue is likely with your BMW.
2. In such cases, you should still see the blue CHIGEE dashboard interface appear.

If only partial data is shown, this means your BMW is transmitting limited information. The CHIGEE Display can only display what your BMW provides — it cannot control or expand the data stream.